Get the Flash Player to see this player.

What sPOD is:

  • The ORIGINAL over the windshield switch console (made of aluminum, NOT plastic).
  • The innovator and the FIRST power distribution system engineered/designed for Toyota FJ Cruisers, Toyota Tacomas (2005 - 2010) and Jeep Wranglers (1997 - 2010) since 2005.
  • An independent power distribution system that consists of a six-circuit/relay/fuse power distribution unit.
  • Switch console with 6 lighted (when in the on position) Contura rocker switches made by Carling Technologies.
  • Two 8 gauge power cables with an inline circuit breaker that attaches to the battery.
  • Two piece wire harness that attaches to the control switch panel and power distribution unit.
    Click Here for more product info...

 



How the system works:

  • Using switches to control the power distribution unit.
  • Its power comes directly from the battery's positive and negative terminals.
  • The power distribution unit supplies power to the 12 position terminal block where accessories will attach.
  • Each circuit is independent with its own relay, fuse, diode (included with each kit). Each circuit is controlled by the sPOD switch panel located inside the cab on the windshield frame utilizing existing hardware to mount.
  • Run your accessory power leads (positive and negative) directly to the terminal block located on the Source.
    Click Here for FAQ's...

Connect with us and become a fan!

findus

 

sPOD Products

square-jksquare-tjsquare-toysquare-acc

magazines

sPOD is a proud member of:

cal4wd_logo

Site Information NOTE: All Logos, Images and Trademarks on this website are the property of their respective owners.

Contact Information 661.755.8139
John@4x4s-POD.com
www.4x4spod.com
Santa Clarita, CA
Precision Designs
CEO: John Angelastro

More Info

Below is a list of various accessories most people control with their sPOD system:

Fog lights, air compressor, ARB and Engle fridges, welder, under Jeep lighting, under vehicle lighting, rear locker, front locker, fuel pump, seat heaters, sub-woofer, inverter, off-road lights, back-up lights, air horns, snow plow, in-motion camera, dual batteries, auxiliary fan, OBA air, windshield lights, GPS power.

We pride ourselves in the fact that our system does NOT tie into, connect to or rely on the vehicles CAN-Bus or Multiplex wiring system.
Maintaining a separate Jeep switches, control/power distribution system for all your accessories is one of the safest ways to control and power the above-mentioned items.

jeep power distribution system, jeep console switch console, jeep switch panel, jk control switches, tj control switches, tj switch panel, jk switch panel, jeep switch panel, low volt battery protector, switches for my jeep
.

 

Read more...